LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Mustang Mach-E Select, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake Actuation >> Removal And Installation >> Brake Pedal and Bracket >> Removal

Brake Pedal and Bracket: Removal

NOTE: Removal steps in this procedure may contain installation details.
  1. Remove the cowl panel grille. Refer to: Cowl Panel Grille .
  2. Remove the 2 LH side (under hood) instrument panel bolts

    Torque: 18 lb.ft (25 Nm)

    GFD609044Courtesy of FORD MOTOR COMPANY
  3. Release the clips and remove the LH instrument panel side trim panel. Use the General Equipment: Interior Trim Remover
    GFD609045Courtesy of FORD MOTOR COMPANY
  4. Remove the cowl side trim panel.

    1. Release the cowl side trim panel lower clips. Use the General Equipment: Interior Trim Remover
    2. Release the cowl side trim panel upper tab.

    GFD609046Courtesy of FORD MOTOR COMPANY
    1. Remove the LH trim panel screw.
    2. Release the clips, disconnect the electrical connector and remove the LH trim panel.
    GFD609047Courtesy of FORD MOTOR COMPANY
  6. Remove the LH instrument panel bolts, and pull the left side of the instrument panel rearward to get access to the brake pedal.

    Torque: 18 lb.ft (25 Nm)

    GFD609048Courtesy of FORD MOTOR COMPANY
  7. Remove the accelerator pedal.
  8. Detach the harness retainers and position the wiring aside.
    GFD609049Courtesy of FORD MOTOR COMPANY
  9. Remove and discard the clevis pin.
    GFD609050Courtesy of FORD MOTOR COMPANY
  10. Remove the brake pedal bracket nuts.
    GFD609051Courtesy of FORD MOTOR COMPANY
  11. This step requires the aid of another technician.

    Pull the LH side of the instrument panel away from the cowl slightly and remove the brake pedal and bracket.

GFD609052Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals