Engine Mount RH: Removal

All vehicles 

1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview .
2. Release the fuel system pressure. Refer to: Fuel System Pressure Release .
3. Disconnect the battery ground and positive cables. Refer to: Battery Disconnect and Connect .
4. Remove the following items:
   1. Air cleaner. Refer to: Air Cleaner .
   2. Intake manifold. Refer to: Intake Manifold .

5. Remove the retainers and the radiator top shield.

   Courtesy of FORD MOTOR COMPANY

6. Remove the LH engine mount nut.

   Courtesy of FORD MOTOR COMPANY

7. Remove the RH engine mount nut.

   Courtesy of FORD MOTOR COMPANY

8. NOTE: Do not position the legs of the Engine Support Bar on the fenders. Instead, the legs should be positioned on the body structure. Failure to follow these instructions may result in body damage.

   Install the special tools and raise the engine 50 mm (2 inch). Install Special Service Tool: 303-639 Support Bracket, Engine., 303-F070 Support Bar, Engine.

   Courtesy of FORD MOTOR COMPANY

   Mach 1 

9. Remove the pin type retainers.

   Courtesy of FORD MOTOR COMPANY

10. Remove the pin type retainers.

    Courtesy of FORD MOTOR COMPANY

11. 1. Remove the bolts.
    2. Remove the pin type retainer and the underbody shield.

    Courtesy of FORD MOTOR COMPANY

    All vehicles 

12. Remove the bolts and the engine mount.

Courtesy of FORD MOTOR COMPANY