Timing Chain Tensioner: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: If the timing chain tensioner plunger is not pinned in the compressed position, follow the next step.

Reset the timing chain tensioner.
1. Position the timing chain tensioner in a soft-jawed vise.
2. Spread the ends of the ratchet wire clip apart.
3. Using the soft-jawed vise, compress the plunger to the reset position.
4. Install a locking pin in the 2 holes of the timing chain tensioner body to hold the plunger in place.
Courtesy of FORD MOTOR COMPANY
NOTE: Do not remove the locking pin until the tensioner bolts are tightened.
1. Install the timing chain tensioner and the bolts.
  Torque: 97 lb.in (11 Nm)
2. Remove the locking pin.
Courtesy of FORD MOTOR COMPANY
Install the engine front cover. Refer to: Engine Front Cover .