Removal And Installation: Flexplate: Installation

WARNING: This page is about a different variant/trim than selected.

- NOTE: Special bolts are used for installation. Do not use standard bolts.
  
  Install the flexplate and the new bolts.
  
  Torque: Stage 1: 37 lb.ft (50 Nm) | Stage 2: 59 lb.ft (80 Nm) | Stage 3: 83 lb.ft (112 Nm)
- Remove Special Service Tool: 303-103 (T74P-6375-A) Holding Tool, Flywheel.
Fig 1: Flexplate Bolts Tightening Sequence
Courtesy of FORD MOTOR COMPANY
Install the automatic transmission. Refer to: Transmission - 2.3L EcoBoost (231kW/314PS)/2.3L EcoBoost (257kW/350PS) - MI4 .
Use the Powertrain Control Module (PCM) Misfire Monitor Profile Correction routine in the diagnostic scan tool.