LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Mustang Mach 1 Premium, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 27 (Fuel Charging And Controls - 5.2L 32V Ti-VCT - Supercharged) >> Removal And Installation >> Fuel Pump Driver Module (FPDM) >> Removal

Fuel Pump Driver Module (FPDM): Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: The fuel pump driver module assembly is located in the luggage compartment, behind the left side luggage compartment carpet.
  1. For the fuel pump driver module component location information. Refer to: Fuel Charging and Controls - Component Location .
  2. Remove the luggage compartment left side carpet retainer, then position the carpet down, out of the way.
    GFD717745Courtesy of FORD MOTOR COMPANY
  3. Disconnect the fuel pump driver module electrical connectors, then detach the wire harness retainers.
    GFD717746Courtesy of FORD MOTOR COMPANY
  4. Remove the fuel pump driver module assembly retainers, then remove the fuel pump driver module assembly.
    GFD717747Courtesy of FORD MOTOR COMPANY
  5. Remove the fuel pump driver module retainers, then remove the fuel pump driver modules from the bracket.
GFD717748Courtesy of FORD MOTOR COMPANY