Diagnostic Trouble Code (DTC) Chart
WARNING: This page is about a different variant/trim than selected.
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| Module | DTC | Description | Action |
|---|---|---|---|
| PCM | P00FE:00 | EVAP System Tank Vapor Line Restricted/Blocked: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0442:00 | EVAP System Leak Detected (small leak): No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0443:00 | EVAP System Purge Control Valve 'A' Circuit: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0446:00 | EVAP System Vent Control Circuit: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0451:00 | EVAP System Pressure Sensor/Switch 'A' Circuit Range/Performance: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0452:00 | EVAP System Pressure Sensor/Switch 'A' Circuit Low: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0453:00 | EVAP System Pressure Sensor/Switch 'A' Circuit High: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0454:00 | EVAP System Pressure Sensor/Switch 'A' Circuit Intermittent: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0455:00 | EVAP System Leak Detected - Large Leak: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0456:00 | EVAP System Leak Detected (very small leak): No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0457:00 | EVAP System Leak Detected (fuel cap loose/off): No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0496:00 | EVAP System High Purge Flow: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P04F0:00 | EVAP System High Load Purge Line 'A' Performance: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P144A:00 | EVAP System Purge Vapor Line Restricted/Blocked: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P144C:00 | EVAP System Purge Flow Performance During Boost: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P1450:00 | Unable to Bleed Up Fuel Tank Vacuum: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P2418:00 | EVAP System Switching Valve 'A' Control Circuit/Open: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P2450:00 | EVAP System Switching Valve 'A' Perfomance/Stuck Open: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P260F:00 | EVAP System Monitoring Processor Performance: No Sub Type Information | GO to Pinpoint Test HX |