Ignition Coil-On-Plug: Removal

Left side: 

1. Remove the following items:
   1. Disconnect the crank case sensor connector.
   2. Disconnect the PCV quick release coupling and position aside PCV hoses out of the way. Refer to: Quick Release Coupling .

   Courtesy of FORD MOTOR COMPANY

2. Remove the LH ignition coil-on-plug cover.

   Courtesy of FORD MOTOR COMPANY

3. Depress the locking tab on each ignition coil-on-plug electrical connector, and disconnect them from the ignition coils.

   Courtesy of FORD MOTOR COMPANY

4. NOTE: Use compressed air to remove any foreign material from the ignition coil-on-plugs and surrounding area before removing the ignition coil-on-plug assemblies.
   NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
   1. Remove the ignition coil-on-plug mounting bolts.
   2. Remove the ignition coil-on-plugs.

   Courtesy of FORD MOTOR COMPANY

   Right side: 

5. • Disconnect the quick connect coupling. Refer to: Quick Release Coupling .

   Courtesy of FORD MOTOR COMPANY

6. Remove the RH Ignition coil on plug cover.

   Courtesy of FORD MOTOR COMPANY

7. Depress the locking tab on each ignition coil-on-plug electrical connector, and disconnect them from the ignition coils.

   Courtesy of FORD MOTOR COMPANY

8. NOTE: Use compressed air to remove any foreign material from the ignition coil-on-plugs and surrounding area before removing the ignition coil-on-plugs.
   NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
   1. Remove the ignition coil-on-plug bolts.
   2. Remove the ignition coil-on-plugs.

Courtesy of FORD MOTOR COMPANY