Transmission Fluid Cooler Tubes: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
The front and rear transmission fluid cooler tubes are covered in the procedure. Remove the transmission fluid cooler tube(s) as necessary.
- Position the vehicle on a hoist. Refer to: Jacking and Lifting - Overview .
- Remove the bolts and position the degas bottle aside.
Torque: 80 lb.in (9 Nm)
- Remove the cooler line connection secondary latches.
-
NOTE: Be prepared to collect escaping fluid.
Remove the transmission cooler line connection clips and disconnect the rear transmission fluid cooler tubes from the front transmission fluid cooler tubes.
- Remove the engine front undershield. Refer to: Engine Front Undershield - GT500 .
-
NOTE: Front transmission fluid cooler tube
Remove the cooler line connection secondary latches.
-
NOTE: Front transmission fluid cooler tubeNOTE: Be prepared to collect escaping fluid.
Remove the transmission fluid cooler line connection clips, disconnect and remove the front transmission fluid cooler tubes.
-
NOTE: Rear transmission fluid cooler tube
Remove the rear transmission fluid cooler tube bracket retainers.
-
NOTE: Rear transmission fluid cooler tube
Remove the retainers and transmission heat shield.
-
NOTE: Rear transmission fluid cooler tubeNOTE: Be prepared to collect escaping fluid.
Remove the bolts and the rear transmission fluid cooler tubes.
- Inspect the transmission case to be sure that the transmission fluid cooler inlet tube seals and backing rings were removed with the transmission fluid cooler tubes and are not stuck in the transmission case. If the transmission fluid cooler tube seals or backing rings are stuck in the transmission case, remove the seals and backing rings, if needed.