Oil Pump: Installation

WARNING: This page is about a different variant/trim than selected.

Prime the oil pump. Add 2 tablespoons of clean engine oil to the oil pump and rotate the oil pump by hand.
NOTE: Oil pump must be held against the cylinder block until all bolts are tightened.
1. Rotate the inner rotor of the oil pump assembly to align the flats on the crankshaft and slip the oil pump over the crankshaft until seated against the block.
2. Rotate the oil pump until the bolt holes are aligned to the block and install the fasteners hand tight.
  Torque: Stage 1: A: 89 lb.in (10 Nm) | Stage 2: B: 18 lb.ft (25 Nm) | Stage 3: C: 89 lb.in (10 Nm) | Stage 4: D: 18 lb.ft (25 Nm) | Stage 5: A: 45° | Stage 6: B: 75° | Stage 7: C: 45° | Stage 8: D: 75°
Courtesy of FORD MOTOR COMPANY
Install the crankshaft sprocket.

Courtesy of FORD MOTOR COMPANY
Install the following items:
1. Refer to: Oil Pan .
2. Refer to: Timing Chain .