LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Mustang Mach 1 Premium, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine - 5.2L 32V Ti-VCT - Supercharged) >> Removal And Installation >> Crankshaft Pulley >> Removal

Crankshaft Pulley: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the following items:

    1. Engine front undershield. Refer to: Engine Front Undershield - GT500 .
    2. Cooling fan motor and shroud. Refer to: Cooling Fan Motor and Shroud .
    3. Supercharger belt. Refer to: Supercharger Belt .

  2. NOTE: If further disassembly of the engine will be performed, retain the original crankshaft pulley bolt for removing the crankshaft front seal, and if necessary, turning the crankshaft while the pulley is removed.

    Remove and discard the crankshaft pulley bolt and retain the washer.

    GFD717139Courtesy of FORD MOTOR COMPANY
  3. Remove the bolts.
    GFD717140Courtesy of FORD MOTOR COMPANY
  4. NOTE: Use a commercially available universal puller (such as an OTC 6930, or equivalent) and a universal step plate (such as an OTC 8052, or equivalent).

    Using a Puller, a Step Plate and 2 bolts, remove the crankshaft pulley. Use the General Equipment: Puller

GFD717141Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals