LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Mustang Mach 1 Premium, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Electronic Engine Controls - 5.2L 32V Ti-VCT - Supercharged) >> Removal And Installation >> Supercharger Inlet Pressure Sensor (SCIP) >> Removal

Supercharger Inlet Pressure Sensor (SCIP): Removal

WARNING: This page is about a different variant/trim than selected.
NOTE: Removal steps in this procedure may contain installation details.
  1. Disconnect the electrical connector. Remove the supercharger inlet pressure (SCIP) sensor.

    Torque: 44 lb.in (5 Nm)

GFD718153Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals