Thermostat Housing: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removal steps in this procedure may contain installation details.
- Drain the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .
- Remove the nuts and the engine appearance cover.
- Remove the air cleaner. Refer to: Air Cleaner .
- Disconnect the FRP electrical connector.
- Release the clamp and disconnect the lower radiator hose. Use the General Equipment: Hose Clamp Remover/Installer
- Release the clamp and disconnect the coolant hose. Use the General Equipment: Hose Clamp Remover/Installer
-
NOTE: Inspect the O-ring seal and replace if necessary.
Remove the bolts and the thermostat housing.
Torque: 89 lb.in (10 Nm)