Normal Operation and Fault Conditions
WARNING: This page does not describe the selected car, but rather 38 other vehicles, including the 2024 Ford F-550 Super Duty, 2024 Ford F-450 Super Duty, 2024 Ford F-350 Super Duty, 2024 Ford F-250 Super Duty, and 2023 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
During new module installation, configuration files are loaded into the new module being replaced. If a discrepancy is detected between the modules or an incomplete programming procedure is carried out, a DTC sets.
PPT Z ABS MODULE DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| C1018:61 | Regenerative Braking: Signal Calculation Failure | Sets due to incomplete or improper module programming procedures. |
| C101F:46 | Generic Valve Failure: Calibration/Parameter Memory Failure | Sets due to incomplete or improper module programming procedures. |
| C101F:49 | Generic Valve Failure: Internal Electronic Failure | Sets due to incomplete or improper module programming procedures. |
| U0300:51 | Internal Control Module Software Invompatibility: Not Programmed | Sets due to incomplete or improper module programming procedures. |
| U2017:57 | Control Module Software #2: Invalid/Incompatible Software Component | Sets due to incomplete or improper module programming procedures. |
| U2017:93 | Control Module Software #2: No Operation | Sets due to incomplete or improper module programming procedures. |
| U2018:57 | Control Module Software #3: Invalid/Incompatible Software Component | Sets due to incomplete or improper module programming procedures. |
| U2024:51 | Control Module Cal-Config Data: Not Programmed | This DTC is only present when a new ABS module is installed, the ABS module is flashed or the ABS module is reconfigured. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
| U2200:00 | Control Module Configuration Memory Corrupt: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |