LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Mustang Mach 1 Premium, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Abs Guided Routine Testing - Pinpoint Tests D - ZA) >> Abs Pinpoint Tests >> Pinpoint Tests N: Rear Wheel Speed Sensor Electrical Faults >> Normal Operation and Fault Conditions

Normal Operation and Fault Conditions

WARNING: This page does not describe the selected car, but rather 38 other vehicles, including the 2024 Ford F-550 Super Duty, 2024 Ford F-450 Super Duty, 2024 Ford F-350 Super Duty, 2024 Ford F-250 Super Duty, and 2023 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Active wheel speed sensors generate a square wave signal proportional to wheel speed which is sent to the ABS module. Each wheel speed sensor is connected to the ABS module through 2 wires and a connector at each wheel speed sensor. The 2 circuits provide both sensor power and sensor signal return. When the ignition mode is set to ON, the ABS module carries out a self-test by sending a reference voltage through the wheel speed sensors and their circuitry. 

PPT N ABS MODULE DTC FAULT TRIGGER CONDITIONS

DTC Description Fault Trigger Conditions
C0037:01 Left Rear Wheel Speed Sensor: General Electrical Failure Sets when the wheel speed signal continuously exceeds a specified threshold or is operating outside of the allowable range.
C003A:01 Right Rear Wheel Speed Sensor: General Electrical Failure Sets when the wheel speed signal continuously exceeds a specified threshold or is operating outside of the allowable range.