LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Mustang Mach 1 Premium, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Abs Guided Routine Testing - Pinpoint Tests D - ZA) >> Abs Pinpoint Tests >> Pinpoint Tests DA: SASM Communication Concern With Auxiliary Heater Control Module >> Normal Operation and Fault Conditions

Normal Operation and Fault Conditions

WARNING: This page does not describe the selected car, but rather 38 other vehicles, including the 2024 Ford F-550 Super Duty, 2024 Ford F-450 Super Duty, 2024 Ford F-350 Super Duty, 2024 Ford F-250 Super Duty, and 2023 Ford F-550 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

With the ignition ON, the AHCM sends messages to the SASM through the GWM over the MS-CAN. If the SASM does not receive these messages within a certain time frame (usually less than 1 second), the module sets DTCs. For information on the messages sent to the SASM by the AHCM, refer to the Description and Operation in the Anti-Lock Brake System (ABS) and Stability Control article. 

PPT DA ABS MODULE DTC FAULT TRIGGER CONDITIONS

DTC Description Fault Trigger Conditions
U0425:00 Invalid Data Received From Auxiliary Heater Control Module: No Sub Type Information This DTC sets when the SASM does not receive any data messages from the auxiliary heater control module within the allotted time.