Diagnostic Trouble Code (DTC) Chart
Diagnostics in this Service Information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
| Module | DTC | Description | Action |
|---|---|---|---|
| PCM | P0034:00 | Turbocharger/Supercharger Bypass Valve "A" Control Circuit Low: No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P0035:00 | Turbocharger/Supercharger Bypass Valve "A" Control Circuit High: No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P0234:00 | Turbocharger/Supercharger "A" Overboost Condition: No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P0243:00 | Turbocharger/Supercharger Wastegate Actuator "A": No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P0247:00 | Turbocharger/Supercharger Wastegate Actuator "B": No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P0299:00 | Turbocharger/Supercharger "A" Underboost Condition: No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P25B3:00 | Turbocharger/Supercharger Wastegate "A" Stuck Open: No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P25B4:00 | Turbocharger/Supercharger Wastegate "A" Stuck Closed: No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P25B5:00 | Turbocharger/Supercharger Wastegate "B" Stuck Open: No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P25B6:00 | Turbocharger/Supercharger Wastegate "B" Stuck Closed: No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P2AB7:00 | Wastegate Position Sensor "A" Circuit: No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P2AB8:00 | Wastegate Position Sensor "A" Circuit Low: No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P2AB9:00 | Wastegate Position Sensor "A" Circuit High: No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P2ABA:00 | Wastegate Position Sensor "B" Circuit: No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P2ABB:00 | Wastegate Position Sensor "B" Circuit Low: No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P2ABC:00 | Wastegate Position Sensor "B" Circuit High: No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P2ABD:00 | Turbocharger/Supercharger Wastegate Actuator "A" Driver Current/Temperature Too High: No Sub Type Information | GO to Pinpoint Test HN |
| PCM | P2ABE:00 | Turbocharger/Supercharger Wastegate Actuator "B" Driver Current/Temperature Too High: No Sub Type Information | GO to Pinpoint Test HN |