LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2022 >> Escape Titanium Plug-In Hybrid >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation, Message Center And Warning Chimes (2 Of 2) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test H: The Odometer Is Inoperative

Pinpoint Test H: The Odometer Is Inoperative

  1. Normal Operation and Fault Conditions 

    See Odometer. REFER to: Instrument Panel Cluster (IPC) - System Operation and Component Description .

    If the odometer count message is missing from the PCM through the GWM for 5 seconds or longer, the IPC defaults the odometer display to all dashes (------).

    If the odometer count message is deemed invalid by the IPC, the IPC defaults the odometer display to all dashes (------). If the NVM becomes corrupted or if any NVM failure occurs, odometer displays ERROR.

    Possible Sources 

    • Communication concern
    • GWM
    • PCM
    • IPC

  2. H1 CHECK FOR CORRUPTED NON-VOLATILE MEMORY (NVM)

    • Ignition ON.

    • Observe the message center display area.

    Does the odometer display ERROR? 

    Yes  GO to  H4
    No  GO to  H2

  3. H2 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

    • Using a diagnostic scan tool, perform the IPC self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to the IPC DTC Chart. Refer to Diagnostic Trouble Code (DTC) Chart .
    No  GO to  H3

  4. H3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (DTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Communications Network .
    No  DIAGNOSE all PCM Diagnostic Trouble Codes (DTCs). REFER to the appropriate Electronic Engine Controls article.

  5. H4 CHECK FOR CORRECT IPC (INSTRUMENT PANEL CLUSTER) OPERATION

    • Ignition OFF.

    • Disconnect and inspect the IPC connector.

    • Repair:

      • corrosion (install new connector or terminals - clean module pins)
      • damaged or bent pins - install new terminals/pins
      • pushed-out pins - install new pins as necessary

    • Reconnect the IPC connector. Make sure it seats and latches correctly.

    • Operate the system and determine if the concern is still present.

    Is the concern still present? 

    Yes  CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new IPC. REFER to: Instrument Panel Cluster (IPC) .
    No  The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.
scientia non olet · About LEMON Manuals