Pinpoint Test CE: The Door Ajar Warning Chime Is Inoperative

Normal Operation and Fault Conditions
See Door Ajar Warning Chime. REFER to: Warning Chimes - System Operation and Component Description .

Possible Sources
- Door ajar indication concern
- IPC

CE1 CHECK THE HEADLAMPS ON WARNING CHIME
- Ignition OFF.
- Turn the headlamps on.
- Open the driver door.
- Monitor the headlamps on warning chime.
Does the headlamps on warning chime operate?

Yes GO to Pinpoint Test T

No GO to CE2

CE2 CHECK FOR CORRECT IPC (INSTRUMENT PANEL CLUSTER) OPERATION

Ignition OFF.

Disconnect and inspect the IPC connector.

Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary

Reconnect the IPC connector. Make sure it seats and latches correctly.

Operate the system and determine if the concern is still present.

Is the concern still present?

Yes	CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new IPC. REFER to: Instrument Panel Cluster (IPC) .

No	The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.