Network Message Chart
Module Network Input Messages - IPC
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| Adaptive cruise control gap display | IPMA | Input used to display the adaptive cruise control gap display. |
| Airbag indicator request | RCM | Input used to display the airbag malfunction and service required warning message. |
| Brake fluid level warning | BCM | Input used to display the low brake fluid level warning message. |
| Brake pad wear message request | ABS module | Input used to display the brake pad wear warning message. |
| Brake (red) warning indicator request | ABS module | Input used to display the brake system malfunction warning message. |
| Camera status display | IPMA | Input used for the lane keeping alert system display. Input used for the auto high beam control warning messages. |
| Cruise control set speed display | PCM | Input used to control the cruise control set speed display and the digital speedometer display. |
| Door ajar status | BCM | Input used to display the individual door ajar warning messages. |
| over-temperature indicator | PCM | Input used to display the engine over-temperature warning message. |
| Engine service indication | PCM | Input used to display the service required warning message. |
| Factory-transport mode | BCM | Input used to display the factory mode or transport mode messages. |
| Forward collision alert message request | IPMA | Input used to display the forward collision alert malfunction warning messages. |
| Forward collision alert radar blocked | IPMA | Input used to display the front radar sensor blocked warning message. |
| Hill start assist status | ABS module | Input used to provide the hill start assist warning message display. |
| Ignition key type | BCM | Input used to calculate the Average Fuel Economy (AFE) for MyKey® settings. |
| Ignition status | BCM | Ignition RUN, START and accessory states required for the IPC operating modes and fault reporting. Input used for the odometer display. |
| Lane keeping alert system status display | IPMA | Input used for the lane keeping system warning messages and display. |
| Manual shift indicator display | PCM | Input used to control the upshift and downshift indicator. |
| Odometer count | PCM | Input used to display electrical efficiency Input used for the odometer display. |
| Outside air temperature display | HVAC module | Input used to provide the outside air temperature display. |
| Parking aid fault | PAM | Input used to display the parking aid malfunction and service required warning message. |
| Parking brake warning indicator | BCM | Input used to display the parking brake applied message. |
| Power system status | BCM | Input used to display the charging system warning messages. |
| Stability-traction control indicator request | ABS module | Input used to display the traction control off message. |
| Starter control message request | PCM | Input used to display the press brake or clutch to start and crank time messages. |
| Steering wheel message center switch data | SCCM | Input used to control the message center switch functions in the message center. |
| Traffic sign recognition message request | IPMA | Input used to display the speed limit sign warning message. |
| Transmission gear display | PCM | Transmission gear selection input used for the PRNDL display. |
| Transmission gear display mode | PCM | Transmission range selection input used for the SelectShift® display. |
| Transmission gear lever position | PCM | Input used to display the manual (M) in the PRNDL for the SelectShift® display. |
| Trip odometer verify | PCM | Input used for the trip odometer display. |
| Vehicle speed | PCM | Input used to display to display electrical efficiency and display actual speed. |
| Wheel rotation count | ABS module | Input used for the odometer display. |