Pinpoint Test G: C1034:76 Or C1034:78
- Refer to VEHICLE DYNAMIC SYSTEMS
for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Parking Brake .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition ABS C1034:76 Park Brake: Wrong Mounting Position This DTC sets in continuous memory if the park brake component software sends the indication that the actuator position is not valid. ABS C1034:78 Park Brake: Alignment Or Adjustment Incorrect This DTC sets in continuous memory if the park brake component software sends the indication that the actuator position is not valid. Possible Sources
- The EPB Apply and Release routine was not carried out.
- The EPB actuator is mounted incorrectly.
- G1 CARRY OUT THE ABS (ANTI-LOCK BRAKE SYSTEM) SELF TEST
- Ignition ON.
- Using a diagnostic scan tool, read the ABS DTC.
Is DTC C1034:78 set?
Yes Using the diagnostic scan tool, clear the DTC. No The system is operating correctly at this time.