Rear Parking Aid Camera
NOTE:
Use caution when handling the coaxial cables. Damage may occur if the cable is bent at too sharp of an angle.
The rear parking aid camera is located on the liftgate applique. On vehicles equipped with a 360 degree view camera system, the rear camera communicates with the IPMB through a coaxial cable in a digital serial format (LVDS). On vehicles equipped with the rear only parking aid camera system, the rear camera communicates with the BCM through a LIN circuit. The rear camera, on the rear only parking aid camera system, must be configured using a diagnostic scan tool after replacement in order for all features to operate properly.
On vehicles equipped with the 360 degree view camera system, the 360 degree view camera alignment must be performed after the liftgate, the reversing lamp assembly or the rear camera is removed from the vehicle.