Oil Cooler: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Locate the notch on the base of oil cooler to the anti-rotation feature on the oil filter adapter.

Install the oil cooler and the bolt.

Torque: Stage 1: 17 lb.ft (22.5 Nm) | Stage 2: 75° | Stage 3: Wait 2s | Stage 4: 15°

Courtesy of FORD MOTOR COMPANY
1. Using the hose clamp installer, install the coolant hoses. Use the General Equipment: Hose Clamp Remover/Installer
2. Remove the hose locking pliers.
Courtesy of FORD MOTOR COMPANY
Install LH front fender splash shield. Refer to: Fender Splash Shield .
Inspect and adjust the coolant level in the degas bottle. Refer to: Specifications .
Inspect and adjust the engine oil level. Refer to: Specifications .