Turbocharger Oil Supply Tube LH: Installation
-
NOTE: A new turbocharger oil supply tube filter must be installed. Failure to install a new filter will cause turbocharger failure.
Install the new turbocharger oil supply tube oil filter.
-
-
NOTE: Do not use a metal brush; damage to sealing area will result in leaks.
Carefully use a nylon brush to remove the old seal residue, use brake cleaner to rinse the seal residue out of the turbocharger tube to turbocharger bore and the turbocharger tube to engine bore. Inspect the area for deep scratches and gouges. Install new components as needed.
Material: Motorcraft® Metal Brake Parts Cleaner / PM-4-A, PM-4-B
- Install the new the seals. Lubricate the inner seal surface with clean engine oil. Refer to: LUBRICANTS, FLUIDS, SEALERS AND ADHESIVES .
-
-
-
NOTE: Do not use a metal brush; damage to sealing area will result in leaks.
Carefully use a nylon brush to remove the old O-ring residue and use brake cleaner to rinse the O-ring residue out of the turbocharger tube to turbocharger O-ring bore and the turbocharger tube to engine O-ring bore. Inspect the area for deep scratches and gouges. Install new components as needed.
Material: Motorcraft® Metal Brake Parts Cleaner / PM-4-A, PM-4-B
- Install the turbocharger oil supply tube, then loosely install the bolt.
-
- Connect the turbocharger oil supply tube to the turbocharger, then install and tighten the bolt.
Torque: 89 lb.in (10 Nm)
- Tighten the turbocharger oil supply tube bolt.
Torque: 89 lb.in (10 Nm)
- Install the air cleaner outlet pipe LH. Refer to: AIR CLEANER OUTLET PIPE LH .
- Install the left front fender splash shield. Refer to: FENDER SPLASH SHIELD .
- Check and top off the engine oil level as needed. Refer to: ENGINE OIL .