Ignition Coil-On-Plug: Installation
WARNING: This page is about a different variant/trim than selected.
- Inspect the ignition coil-on-plugs and replace any units with damaged seals or cracks, rips or tears in the rubber boots.
- Install the ignition coil-on-plugs and the mounting bolts. Tighten the bolts.
Torque:
Stage 1: 62 lb.in (7 Nm)
Stage 2: 50°
- Connect the ignition coil-on-plug electrical connectors and connect the high-pressure fuel pump electrical connector.
-
NOTE: When removing or installing the high-pressure fuel pump noise insulator, spreading the openings will reduce the risk of damage.
Install the high-pressure fuel pump noise insulator. Install the high-pressure fuel pump noise insulator retainer.