Cylinder Block
WARNING: This page is about a different variant/trim than selected.
| Item | Specification |
|---|---|
| Block main bore roundness | 0.000 in (.008 mm) |
| Cylinder bore diameter | 3.642 -3.643 in (92.5 -92.52 mm) |
| Cylinder bore roundness | 0.0005 in (.013 mm) |
| Cylinder bore taper | 0.0004 in (.01 mm) |
| Main bearing bore inside diameter | 2.850 -2.851 in (72.4 -72.424 mm) |
| Head gasket surface flatness | Flat within 0.150 mm (0.005 in) overall 0.050 mm (0.001 in) per 150 mm (5.905 in) x 150 mm (5.905 in) 0.025 mm (0.0009 in) per 25 mm (0.98 in) x 25 mm (0.98 in) |