Network Message Chart
Module Network Input Messages - IPC
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| Adaptive cruise control gap display | IPMA | Input used to display the adaptive cruise control gap display. |
| Airbag indicator request | RCM | Input used to display the airbag malfunction and service required warning message. |
| Brake fluid level warning | BCM | Input used to display the low brake fluid level warning message. |
| Brake pad wear message request | ABS module | Input used to display the brake pad wear warning message. |
| Brake (red) warning indicator request | ABS module | Input used to display the brake system malfunction warning message. |
| Camera status display | IPMA | Input used for the lane keeping alert system display. Input used for the auto high beam control warning messages. |
| Cruise control set speed display | PCM | Input used to control the cruise control set speed display and the digital speedometer display. |
| Door ajar status | BCM | Input used to display the individual door ajar warning messages. |
| Engine oil life | PCM | Input used to display the engine oil change required message. |
| Engine over-temperature indicator | PCM | Input used to display the engine over-temperature warning message. |
| Engine RPM | PCM | Input used for the calculation of the instantaneous fuel economy and the Average Fuel Economy (AFE) displays. |
| Engine service indication | PCM | Input used to display the service required warning message. |
| Factory-transport mode | BCM | Input used to display the factory mode or transport mode messages. |
| Forward collision alert message request | IPMA | Input used to display the forward collision alert malfunction warning messages. |
| Forward collision alert radar blocked | IPMA | Input used to display the front radar sensor blocked warning message. |
| Fuel alcohol percent | PCM | Input used for the calculation of the instantaneous fuel economy and the Average Fuel Economy (AFE) displays. |
| Fuel flow volume display | PCM | Input used for the calculation of the instantaneous fuel economy and the Average Fuel Economy (AFE) displays. Input used for Running Average Fuel Economy (RAFE) to calculate the DTE. |
| Hill start assist status | ABS module | Input used to provide the hill start assist warning message display. |
| Ignition key type | BCM | Input used to calculate the Average Fuel Economy (AFE) for MyKey® settings. |
| Ignition status | BCM | Ignition RUN, START and accessory states required for the IPC operating modes and fault reporting. Input used for the odometer display. |
| Lane keeping alert system status display | IPMA | Input used for the lane keeping system warning messages and display. |
| Manual shift indicator display | PCM | Input used to control the upshift and downshift indicator. |
| Odometer count | PCM | Input used for the calculation of the instantaneous fuel economy and the Average Fuel Economy (AFE) displays. Input used for Running Average Fuel Economy (RAFE) to calculate the DTE. Input used for the odometer display. |
| Outside air temperature display | HVAC module | Input used to provide the outside air temperature display. |
| Parking aid fault | PAM | Input used to display the parking aid malfunction and service required warning message. |
| Parking brake warning indicator | BCM | Input used to display the parking brake applied message. |
| Power system status | BCM | Input used to display the charging system warning messages. |
| Stability-traction control indicator request | ABS module | Input used to display the traction control off message. |
| Starter control message request | PCM | Input used to display the press brake or clutch to start and crank time messages. |
| Steering wheel message center switch data | SCCM | Input used to control the message center switch functions in the message center. |
| Traffic sign recognition message request | IPMA | Input used to display the speed limit sign warning message. |
| Transmission gear display | PCM | Transmission gear selection input used for the PRNDL display. |
| Transmission gear display mode | PCM | Transmission range selection input used for the SelectShift® display. |
| Transmission gear lever position | PCM | Input used to display the manual (M) in the PRNDL for the SelectShift® display. |
| Trip odometer verify | PCM | Input used for the trip odometer display. |
| Vehicle speed | PCM | Input used for the calculation of the instantaneous fuel economy and the Average Fuel Economy (AFE) displays. |
| Wheel rotation count | ABS module | Input used for the odometer display. |