LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Mustang Mach-E Premium, AWD >> Repair and Diagnosis >> Electrical >> Gauges >> Instrumentation, Message Center And Warning Chimes >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test E: The Odometer Is Inoperative

Pinpoint Test E: The Odometer Is Inoperative

  1. Normal Operation and Fault Conditions 

    See Odometer. REFER to: Message Center - System Operation and Component Description .

    If the odometer count message is missing from the PCM for 5 seconds or longer, the IPC defaults the odometer display to all dashes (------).

    If the odometer count message is deemed invalid by the IPC, the IPC defaults the odometer display to all dashes (------). If the NVM becomes corrupted or if any NVM failure occurs, odometer displays ERROR.

    Possible Sources 

    • Communication concern
    • PCM concern
    • GWM concern
    • IPC

  2. E1 CHECK FOR CORRUPTED NON-VOLATILE MEMORY (NVM)

    • Ignition ON.

    • Observe the message center display area.

    Does the odometer display ERROR? 

    Yes  INSTALL a new IPC.
    No  GO to  E2

  3. E2 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

    • Using a diagnostic scan tool, perform the IPC self-test.

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to Diagnostic Trouble Code (DTC) Chart .
    No  GO to  E3

  4. E3 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)

    • Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (CMDTCs).

    Are any Diagnostic Trouble Codes (DTCs) recorded? 

    Yes  REFER to: Controller Area Network (CAN) Module Communications Network .
    No  DIAGNOSE all PCM Diagnostic Trouble Codes (DTCs). REFER to the Master DTC Chart.
scientia non olet · About LEMON Manuals