Pinpoint Test BP: Invalid Data Received - Invalid/Incompatible Configuration
- Normal Operation and Fault Conditions
REFER to: Controller Area Network (CAN) Module Communications Network - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition IPC U0405:56 Invalid Data Received From Cruise Control Module: Invalid/Incompatible Configuration Data mismatch between the module configuration and the messaged signals received. IPC U0533:56 Invalid Data Received From Side Obstacle Detection Control Module "A": Invalid/Incompatible Configuration Data mismatch between the module configuration and the messaged signals received. IPC U0534:56 Invalid Data Received From Side Obstacle Detection Control Module "B": Invalid/Incompatible Configuration Data mismatch between the module configuration and the messaged signals received. Possible Sources
- IPC
- BP1 CHECK VEHICLE HISTORY FOR RECENT SERVICE ACTIONS
- Check the vehicle history for any recent service actions related to the IPC.
Have any service actions been performed?
Yes REPEAT the PMI as directed by the diagnostic scan tool. No GO to BP2 - BP2 RECONFIGURE THE MODULE
- Using a diagnostic scan tool, perform the PMI as directed by the diagnostic scan tool.
- Verify the configured feature can be activated and operates correctly.
Is the feature available and working correctly?
Yes The system is operating correctly at this time. The concern may have been caused by incomplete or incorrect PMI procedure. No The IPC fails to retain configuration data. INSTALL a new IPC. REFER to: Instrument Panel Cluster (IPC) .