Diagnostic Trouble Code (DTC) Chart
Diagnostics in this information assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
Diagnostic Trouble Code Chart
| Module | DTC | Description | Action |
|---|---|---|---|
| PCM | P00FE:00 | EVAP System Tank Vapor Line Restricted/Blocked: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0442:00 | EVAP System Leak Detected (Small Leak): No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0443:00 | EVAP System Purge Control Valve A Circuit: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0446:00 | EVAP System Vent Control Circuit: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0451:00 | EVAP System Pressure Sensor / Switch A Circuit Range / Performance: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0452:00 | EVAP System Pressure Sensor / Switch A Circuit Low: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0453:00 | EVAP System Pressure Sensor / Switch A Circuit High: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0454:00 | EVAP System Pressure Sensor / Switch A Circuit Intermittent: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0455:00 | EVAP System Leak Detected (Large Leak): No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0456:00 | EVAP System Leak Detected (Very Small Leak): No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0457:00 | EVAP System Leak Detected (Fuel Cap Loose / Off): No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P0496:00 | EVAP System High Purge Flow: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P04F0:00 | EVAP System High Load Purge Line A Performance: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P144A:00 | EVAP System Purge Vapor Line Restricted/Blocked: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P144C:00 | EVAP System Purge Flow Performance During Boost: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P1450:00 | Unable To Bleed Up Fuel Tank Vacuum: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P2418:00 | EVAP System Switching Valve Control Circuit/Open: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P2450:00 | EVAP System Switching Valve Performance/Stuck Open: No Sub Type Information | GO to Pinpoint Test HX |
| PCM | P260F:00 | EVAP System Monitoring Processor Performance: No Sub Type Information | GO to Pinpoint Test HX |