Engine Mount LH: Removal

All vehicles 

1. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview
2. Release the fuel system pressure. Refer to: Fuel System Pressure Release
3. Disconnect the battery ground and positive cables. Refer to: Battery Disconnect and Connect
4. NOTE: Make sure to minimize damage to sealer foam and avoid pulling apart dash seal brackets from retainer pins. Excessive damage may allow engine noise, fumes, air or water to enter the passenger compartment.
   1. Remove the steering column dash seal nuts.
   2. Loosen the dash seal.
   3. Hand start the dash seal nuts.

   Courtesy of FORD MOTOR COMPANY

5. Using a holding device, hold the steering wheel in the straight-ahead position.

   Courtesy of FORD MOTOR COMPANY

6. Remove the following items:
   1. Air cleaner. Refer to: Air Cleaner
   2. Intake manifold. Refer to: Intake Manifold 

7. Remove the retainers and the radiator top shield.

   Courtesy of FORD MOTOR COMPANY

8. Remove the LH engine mount nut.

   Courtesy of FORD MOTOR COMPANY

9. Remove the RH engine mount nut.

   Courtesy of FORD MOTOR COMPANY

10. NOTE: Do not position the legs of the Engine Support Bar on the fenders. Instead, the legs should be positioned on the body structure. Failure to follow these instructions may result in body damage.

    Install the special tools and raise the engine 50 mm (2 inch). Install Special Service Tool: 303-639 Support Bracket, Engine., 303-F070 Support Bar, Engine.

    Courtesy of FORD MOTOR COMPANY

    Mach 1 

11. Remove the pin type retainers.

    Courtesy of FORD MOTOR COMPANY

12. Remove the pin type retainers.

    Courtesy of FORD MOTOR COMPANY

13. 1. Remove the bolts.
    2. Remove the pin type retainer and the underbody shield.

    Courtesy of FORD MOTOR COMPANY

    All vehicles 

14. WARNING: Do not reuse steering column shaft bolts. This may result in fastener failure and steering column shaft detachment or loss of steering control. Failure to follow this instruction may result in serious injury to vehicle occupant(s).
    WARNING: DO NOT hammer, pry or force steering column and column shafts during installation or removal. Failure to follow this instruction may cause damage to steering components that could lead to loss of steering control during vehicle operation and could result in serious personal injury or death.
    WARNING: DO NOT attempt to remove or install the steering column lower u-joint at the steering gear without first loosening the steering column dash seal and fasteners. Failure to follow this instruction may cause damage to steering components that could lead to loss of steering control during vehicle operation and could result in serious personal injury or death.

    Detach the steering column lower shaft from the lower coupling.

    1. Remove and discard the steering column shaft bolt.
    2. Pull apart the steering column shaft from the coupling.
    3. Secure the lower shaft to the frame rail to avoid damage to the shaft.

    Courtesy of FORD MOTOR COMPANY

15. Remove the bolts and the engine mount.

Courtesy of FORD MOTOR COMPANY