LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Mustang Mach 1, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - 5.0L 32V Ti-VCT (359KW/486PS) (WU)/5.0L Ti-VCT V8 (343KW/466PS) (MF) >> Removal And Installation >> Crankshaft Rear Seal >> Removal

Crankshaft Rear Seal: Removal

  1. Remove the flexplate or flywheel. Refer to: Flexplate . Refer to: Flywheel 
  2. Remove the crankshaft sensor ring and the engine-to-transmission spacer plate.
    GFD600419Courtesy of FORD MOTOR COMPANY
  3. Inspect the crankshaft sensor ring for damage. If the crankshaft sensor ring has been dropped or has any visual damage, it must be discarded.
    GFD600420Courtesy of FORD MOTOR COMPANY
  4. Using the special tools, remove and discard the crankshaft rear seal. Use Special Service Tool: 303-519 (T95P-6701-EH) Remover, Crankshaft Rear Oil Seal., 100-001 (T50T-100-A) Slide Hammer.
GFD600421Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals