LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Mustang Mach 1, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine - 5.0L 32V Ti-VCT (359KW/486PS) (WU)/5.0L Ti-VCT V8 (343KW/466PS) (MF) >> Removal And Installation >> Crankshaft Rear Seal >> Installation

Crankshaft Rear Seal: Installation

  1. Lubricate the seal bore and the seal lips with clean engine oil.
    GFD600422Courtesy of FORD MOTOR COMPANY
    • Position the special tool onto the end of the crankshaft. Use Special Service Tool: 303-1250 Seal Installer, Rear Main.

    • Slide the new crankshaft rear seal onto the tool.

    GFD600423Courtesy of FORD MOTOR COMPANY
  3. Using the special tools, install the crankshaft rear seal. Use Special Service Tool: 205-153 (T80T-4000-W) Handle., 303-1250 Seal Installer, Rear Main.
    GFD600424Courtesy of FORD MOTOR COMPANY
  4. Install the crankshaft sensor ring and the engine-to-transmission spacer plate.
    GFD600419Courtesy of FORD MOTOR COMPANY
  5. Install the flexplate or flywheel. Refer to: Flexplate . Refer to: Flywheel 
  6. Road test the vehicle.
scientia non olet · About LEMON Manuals