Camshaft RH: Installation

NOTE: If the components are to be reinstalled, they must be installed in their original locations.
1. Assemble the hydraulic lash adjusters onto the spring clips on the camshaft roller followers.
2. Lubricate the camshaft roller follower and hydraulic lash adjuster assemblies with clean engine oil.
3. Install the camshaft roller follower and hydraulic lash adjuster assemblies.
Courtesy of FORD MOTOR COMPANY
NOTE: Lubricate the camshafts with clean engine oil prior to installation.

Install the intake and exhaust camshafts in the neutral position. Align the D-slots as shown in the illustration.

Courtesy of FORD MOTOR COMPANY
Install the camshaft bearing caps and the bolts. Do not tighten at this time.

Courtesy of FORD MOTOR COMPANY
Install the front camshaft bearing mega cap and the bolts. Do not tighten at this time.

Courtesy of FORD MOTOR COMPANY
Tighten the bolts in sequence.
Torque: Stage 1: Bolts 1-19: 53 lb.in (6 Nm) Stage 2: Bolts 1-2, 5-10, 13-19: 45 deg. Bolts 3-4, 11-12: 90 deg.

Fig 1: Front Camshaft Bearing Cap RH Bolts Tightening Sequence
Courtesy of FORD MOTOR COMPANY
Install a new VCT system oil filter into the camshaft.

Courtesy of FORD MOTOR COMPANY
Install the RHVCT units. Refer to: Variable Camshaft Timing (VCT) Unit
Road test the vehicle.