LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Mustang Mach 1, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling - 5.0L 32V Ti-VCT (359KW/486PS) (WU)/5.0L Ti-VCT V8 (343KW/466PS) (MF) >> Removal And Installation >> Thermostat >> Installation

Removal And Installation: Thermostat: Installation

    1. Install a new O-ring seal and lubricate it with clean engine coolant.

      Material

      : Motorcraft® Orange Concentrated Antifreeze/Coolant / VC-3-B (WSS-M97B44-D)

    2. To install, reverse the removal procedure.
  2. Fill and bleed the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding .
scientia non olet · About LEMON Manuals