Pinpoint Test BR: The OVERSPEED Warning Chime Is Inoperative (Gulf Cooperative Countries [GCC])

Normal Operation and Fault Conditions
See Overspeed Warning Chime. REFER to: Instrumentation, Message Center and Warning Chimes .

Possible Sources
- Speedometer indication concern
- IPC configuration concern
- IPC

BR1 CHECK THE SEATBELT WARNING CHIME OPERATION
- Ignition OFF.
- Ignition ON.
- Unbuckle the driver seatbelt.
- Monitor the seatbelt warning chime when the ignition is transitioned from OFF to RUN for 6 seconds.
Does the seatbelt warning chime operate for approximately 6 seconds?

Yes GO to BR2

No GO to Pinpoint Test BV

BR2 CHECK THE SPEEDOMETER OPERATION
- Verify the speedometer operates.
Does the speedometer operate?

Yes GO to BR3

No GO to Pinpoint Test E

BR3 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST

Using a diagnostic scan tool, perform the IPC self-test.

Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes	REFER to DTC Chart: Instrument Panel Cluster (IPC) .

CONFIRM the vehicle was built for the Gulf Cooperative Country [GCC] market. If the vehicle was not built for a Gulf Cooperative Country [GCC], the IPC is functioning correctly. If the vehicle was built for a Gulf Cooperative Country [GCC], PERFORM the Programmable Module Installation (PMI) procedure using as built data as directed by the diagnostic scan tool. REFER to: Module Configuration - System Operation and Component Description