Pinpoint Test AE: A Virtual Display (Accelerometer, Exhaust Mode, Launch Control, Or Track Apps [Acceleration Timer, Brake Performance, Lap Timer Or Engine Rev Match]) Display Is Inoperative

Normal Operation and Fault Conditions
See Accelerometer, Exhaust Mode, Launch Control or Track Apps display. REFER to: Message Center - System Operation and Component Description .

Possible Sources
- Communication concern
- ABS module concern
- PCM concern
- BCM concern
- GWM concern
- IPC

AE1 VERIFY THE LANE DEPARTURE IS TURNED OFF
- Ignition ON.
- NOTE: The virtual display may be disabled (grayed out) if the lane departure feature is turned on.
  
  Verify the lane departure is turned off using the lane keeping system switch. REFER to: Lane Keeping System - Component Location . or REFER to: Lane Keeping System - Overview
Is the lane departure turned off?

Yes GO to AE2

No TURN OFF the lane departure feature.

AE2 VERIFY THE APPLICABLE DISPLAY MODE IS ENABLED THROUGH THE MESSAGE CENTER
- NOTE: The IPC and message center navigation can be found in the Owner's Literature.
  
  Using the message center controls, verify the display mode in question is enabled.
Is the display mode in question enabled?

Yes GO to AE3

No ENABLE the desired display mode. The system is operating correctly.

AE3 PERFORM THE IPC (INSTRUMENT PANEL CLUSTER) SELF-TEST
- Using a diagnostic scan tool, perform the IPC self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes REFER to DTC Chart: Instrument Panel Cluster (IPC) .

No GO to AE4

AE4 CHECK THE GWM (GATEWAY MODULE A) DIAGNOSTIC TROUBLE CODES (DTCS)
- Using a diagnostic scan tool, check the GWM Continuous Memory Diagnostic Trouble Codes (CMDTCs).
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes REFER to: Communications Network

No GO to AE5

AE5 PERFORM THE ABS (ANTI-LOCK BRAKE SYSTEM) MODULE SELF-TEST
- Using a diagnostic scan tool, perform the ABS module self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes REFER to: Anti-Lock Brake System (ABS) and Stability Control

No GO to AE6

AE6 PERFORM THE PCM (POWERTRAIN CONTROL MODULE) KOEO (KEY ON, ENGINE OFF) SELF-TEST
- Using a diagnostic scan tool, perform the PCM KOEO self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes REFER to the appropriate Electronic Engine Controls article.

No GO to AE7

AE7 PERFORM THE BCM (BODY CONTROL MODULE) SELF-TEST
- Using a diagnostic scan tool, perform the BCM self-test.
Are any Diagnostic Trouble Codes (DTCs) recorded?

Yes REFER to: Body Control Module (BCM)

No INSTALL a new IPC. Refer to Instrument Panel Cluster (IPC) .