Front Muffler: Installation
- To install, reverse the removal procedure.
- Clean all exhaust connections before reassembly.
- Connect the front muffler to the rear muffler entry pipes using exhaust clamps.
Torque
: 35 lb.ft (48 Nm)
-
NOTE: Make sure the decorative tips of both rear mufflers are properly aligned with the openings in the rear bumper cover and adjust if needed.
Tighten the clamps in the sequence shown in illustration.
Torque
: 35 lb.ft (48 Nm)
- Check the exhaust system for leaks and noise/vibrations.