LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2021 >> Mustang GT, Automatic Trans >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake And Actuation - Vehicles With: Conventional Mechanical Parking Brake >> Diagnosis And Testing >> Parking Brake >> Pinpoint Tests >> Pinpoint Test A: The Parking Brake Does Not Apply Or Does Not Hold Vehicle >> Pinpoint Test A: The Parking Brake Does Not Apply Or Does Not Hold Vehicle

Pinpoint Test A: The Parking Brake Does Not Apply Or Does Not Hold Vehicle

  1. A1 CHECK THE PARKING BRAKE CONTROL

    • Pull up the parking brake control handle.

    Does the parking brake control move? 

    Yes  GO to  A2
    No  GO to  A3
  2. A2 INSPECT THE FOLLOWING PARKING BRAKE COMPONENTS

    NOTE: Have an assistant pull and release the parking brake to help isolate disconnected cables or cables that do not move.

    • Parking brake control

    • Front parking brake cable

    • Rear parking brake cables and/or equalizer

    • Rear brake caliper actuators

    Is any damage found or are any components disconnected? 

    Yes  CONNECT the component(s) or INSTALL new parking brake component(s) as necessary. TEST the system for normal operation. ADJUST the parking brake cables. REFER to: Parking Brake Cable Adjustment 
    No  VERIFY that the rear pads and brake discs are within thickness specifications. REFER to: Specifications . If the rear pads and brake discs are OK, INSTALL new rear brake caliper(s). REFER to: Brake Caliper
  3. A3 ISOLATE THE PARKING BRAKE CONTROL AND FRONT PARKING BRAKE CABLE

    • Disconnect the front parking brake cable from the rear parking brake cable equalizer.

    • Pull up the parking brake control handle.

    Does the parking brake control handle move? 

    Yes  GO to  A4
    No  INSTALL a new parking brake control and front cable assembly as necessary. REFER to: Parking Brake Control  . TEST the system for normal operation.
  4. A4 ISOLATE THE REAR PARKING BRAKE CABLES

    • Disconnect the rear parking brake cable from the rear brake caliper at the affected wheel end(s).

    • While holding the cable conduit, attempt to slide the cable inside the conduit.

    Does the cable slide freely inside the conduit? 

    Yes  The parking brake system is operating normally at this time. INSPECT the rear brake components on the affected wheel end(s). INSTALL new rear brake components as necessary and ADJUST the parking brake cables. REFER to: Parking Brake Cable Adjustment 
    No  INSTALL new RH or LH rear parking brake cables as necessary. REFER to: Parking Brake Cable LH . REFER to: Parking Brake Cable RH 
    1