Manual Zoom

The manual zoom feature is controlled by the rear parking aid video camera and has one level of zoom. If the manual zoom feature is on and the vehicle is shifted out of reverse gear, the manual zoom feature is disabled. The manual zoom feature must be re-enabled the next time reverse gear is selected.

When the manual zoom feature is turned on, only the centerline is present with no other guidelines even if the fixed and/or active guidelines are selected on.

When the driver turns the zoom on or off at the FDIM or FCDIM, the command is sent by the APIM over the HS-CAN3 to the GWM. The GWM then sends the command to the BCM on the HS-CAN1. The BCM sends the manual zoom request message to the parking aid camera via the LIN circuit. The camera then turns the zoom on or off.