Pinpoint Test DJ : P1534:01

DTC Fault Trigger Conditions

DTC	Description	Fault Trigger Condition
IPC P1534:01	Restraint Deployment Indicator Circuit: General Electrical Failure	Sets in the IPC if a fault is detected with the airbag warning indicator or RTT warning indicator.

Possible Sources

IPC
SRS system concern

DJ1 RETRIEVE IPC (INSTRUMENT PANEL CLUSTER) DIAGNOSTIC TROUBLE CODES (DTCS)

Ignition ON.

Using a diagnostic scan tool, clear the Diagnostic Trouble Codes (DTCs).

Wait 10 seconds.

Using a diagnostic scan tool, perform the IPC self-test.

Is P1534:01 recorded?

Yes	GO to DJ2 If the concern is still present, DIAGNOSE all RCM Diagnostic Trouble Codes (DTCs). REFER to: Airbag Supplemental Restraint System (SRS) .

No	The system is operating correctly at this time.

DJ2 CHECK FOR CORRECT IPC (INSTRUMENT PANEL CLUSTER) OPERATION

Ignition OFF.

Disconnect and inspect the IPC connector.

Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary

Reconnect the IPC connector. Make sure it seats and latches correctly.

Operate the system and determine if the concern is still present.

Is the concern still present?

Yes	CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, INSTALL a new IPC. REFER to: Instrument Panel Cluster (IPC) .

No	The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.