BeltMinder® Feature

NOTE: Whenever the vehicle is operated using MyKey®, the IPC enables the Belt-Minder®.

The BeltMinder® is configurable on or off. Refer to: Seatbelt Minder Deactivating/Activating .

The BeltMinder® feature supplements the current seatbelt warning function and is enabled after the current seatbelt warning is complete. The BeltMinder® reminds the driver the driver or front passenger seatbelt is unbuckled by intermittently sounding a chime and simultaneously illuminating the seatbelt warning indicator through the front speakers. The BeltMinder® begins once the current seatbelt warning has ended and the vehicle speed has exceeded 10 km/h (6 mph) with the driver or front passenger seatbelt unbuckled. While activated, the BeltMinder® chime provides a series of chimes/seatbelt warning indicator flash sequences.

If the vehicle speed drops below 5 km/h (3 mph) once the BeltMinder® chime has activated, the chime turns off and the seatbelt warning indicator remains on. When the vehicle speed exceeds 10 km/h (6 mph) again, the BeltMinder® chime resumes.

When MyKey® is in use, the driver cannot configure the Belt-Minder® off. Once the Belt-Minder® is activated, the Belt-Minder® continues to chime periodically (does not time out after 5 minutes) and the audio system is muted until the driver and passenger seatbelts are fastened.

To control the BeltMinder®, the IPC receives the vehicle speed, gear lever position, driver and passenger seatbelt buckle status messages from the GWM over the HS-CAN3.

The GWM receives the vehicle speed and gear lever position messages from the PCM over the HS-CAN1.

The IPC receives the driver and passenger seatbelt status messages from the RCM over the HS-CAN2.

When the conditions require the Belt-Minder® chime, the IPC sends the IPC chime request message to the ACM or DSP (if equipped) to sound the chime.