360° Degree View Camera
diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .
NOTE:
Use caution when handling the coaxial cables. Damage may occur if the cable is bent at too sharp of an angle.
| Condition | Possible Sources | Actions |
|---|---|---|
| The camera system does not respond when the camera selection switch is pressed | Refer to the Pinpoint Test | GO to Pinpoint Test Q |
| The Rear 360° + Normal view is not displayed on the audio system display when reverse gear is selected | Refer to the Pinpoint Test | GO to Pinpoint Test M |
| All 360° degree camera views are inoperative or do not operate correctly | Refer to the Pinpoint Test | GO to Pinpoint Test K |
| One or more (not all) 360° degree camera views are inoperative or do not operate correctly | Refer to the Pinpoint Test | INSPECT the camera views to determine which camera(s) is/are inoperative: For the rear camera, GO to Pinpoint Test M For the front camera, GO to Pinpoint Test N For the LH side camera, GO to Pinpoint Test O For the RH side camera, GO to Pinpoint Test P |
| Static/flashing/blinking/flickering/scrolling or rolling image/screen/scrolling horizontal lines for one or more 360° degree camera views | Refer to the Pinpoint Test | GO to Pinpoint Test L |
| Poor image quality (foggy/cloudy/fuzzy/blurry/hazy image or moisture/water in lens or black spots) for one or more 360° degree camera views | Refer to the Pinpoint Test | GO to Pinpoint Test L |
| The lower corners of the front, rear, or side camera image in the 360° degree camera view show vertical colored lines or appear grayed out | Refer to the Pinpoint Test | PERFORM the 360° degree camera alignment. REFER to: 360° Degree View Camera Alignment . If the concern is still present after performing the 360° degree camera alignment, GO to Pinpoint Test L |
| Frozen or slow screen transitions between camera views | IPMB | INSTALL a new IPMB. REFER to: Image Processing Module B (IPMB) . |
| One or more of the images in the 360° degree camera view is misaligned | Camera alignment | PERFORM the 360° degree view camera alignment. REFER to: 360° Degree View Camera Alignment . |
| Manual zoom function is inoperative (rear parking aid camera image only) | Refer to the Pinpoint Test | GO to Pinpoint Test T |
| Visual park aid alert is inoperative | Refer to the Pinpoint Test | GO to Pinpoint Test R |
| Active guidelines are inoperative or do no operate correctly (rear parking aid camera image only) | Refer to the Pinpoint Test | GO to Pinpoint Test S |
| Fixed guidelines are inoperative or do not operate correctly (rear parking aid camera image only) | Refer to the Pinpoint Test | GO to Pinpoint Test S |
| The video delay feature is inoperative or does not operate correctly (rear parking aid camera image only) | Refer to the Pinpoint Test | GO to Pinpoint Test F |
| The front camera washer is inoperative | Front camera washer hose Front camera washer jet |
REFER to: Wipers and Washers . |