Symptom Chart

WARNING: This page is about a different variant/trim than selected.

For F clutch operation, REFER to: F Clutch .

Condition	Possible Sources	Action
F clutch does not apply	SSF is mechanically stuck OFF	INSTALL a new solenoid. REFER to: Shift Solenoids (SS) .
	F Clutch regulator valve stuck OFF	DISASSEMBLE, CLEAN and INSPECT the regulator valve. If bore or valve is damaged, INSTALL a new main control valve body. REFER to: Main Control Valve Body .
	F CL CONTR, hydraulic circuit blocked/leaking	DISASSEMBLE and INSPECT the main control valve body and separator plate passages for debris/blockage. CLEAN as necessary. REFER to: Main Control Valve Body .
	F clutch hub	INSPECT components wear and damage. CLEAN and/or INSTALL new components as necessary. REFER to: Transmission
	F clutch friction plates	INSPECT components wear and damage. CLEAN and/or INSTALL new components as necessary. REFER to: Transmission
	F clutch piston seals	INSPECT components wear and damage. CLEAN and/or INSTALL new components as necessary. REFER to: Transmission
F clutch always applied	SSF mechanically stuck	INSTALL a new solenoid. REFER to: Shift Solenoids (SS) .
	F Clutch regulator valve or CL F latch valve stuck ON	DISASSEMBLE, CLEAN and INSPECT the regulator valve. If bore or valve is damaged, INSTALL a new main control valve body. REFER to: Main Control Valve Body .
	F CL CONTR, hydraulic circuit cross leaks	DISASSEMBLE and INSPECT the main control valve body and separator plate passages for debris/blockage. CLEAN as necessary. REFER to: Main Control Valve Body .
	F clutch hub, clutch and planetary carrier, No. 4 ring gear	INSPECT components wear and damage. CLEAN and/or INSTALL new components necessary. REFER to: Transmission
	F clutch friction plates	INSPECT components wear and damage. CLEAN and/or INSTALL new components necessary. REFER to: Transmission
	F clutch piston seals	INSPECT components wear and damage. CLEAN and/or INSTALL new components necessary. REFER to: Transmission
F clutch delayed/soft/slipping apply	Incorrect transmission strategy programmed into PCM/TCM.	PERFORM the Transmission Strategy Download, REFER to: Transmission Strategy Download .
	Low line pressure	PERFORM the line pressure test. REFER to: Special Testing Procedures .
	SSF mechanically sticking	If the vehicle has less than 5, 000 miles (8, 000 km), CARRY OUT the PCM - Transmission Accelerated Main Control Break In routine 3 times using the diagnostic scan tool. For all other vehicles, INSTALL a new solenoid. REFER to: Shift Solenoids (SS) .
	F Clutch regulator valve sticking	If the vehicle has less than 5, 000 miles (8, 000 km), CARRY OUT the PCM - Transmission Accelerated Main Control Break In routine 3 times using the diagnostic scan tool. For all other vehicles, DISASSEMBLE, CLEAN and INSPECT the valves. If bore or valve is damaged, INSTALL a new main control valve body. REFER to: Main Control Valve Body .
	F CL CONTR, hydraulic circuits blocked/leaking	DISASSEMBLE and INSPECT the main control valve body and separator plate passages for debris/blockage. CLEAN as necessary. REFER to: Main Control Valve Body .
	F clutch friction plates	DISASSEMBLE and INSPECT the transmission passages for debris/blockage. CLEAN as necessary. REFER to: Transmission
	F clutch piston seals	DISASSEMBLE and INSPECT the transmission passages for debris/blockage. CLEAN as necessary. REFER to: Transmission
F clutch harsh apply	Incorrect transmission strategy programmed into PCM/TCM.	PERFORM the Transmission Strategy Download, REFER to: Transmission
	High line pressure	PERFORM line pressure test. REFER to: Special Testing Procedures .
	SSF mechanically sticking	If the vehicle has less than 5, 000 miles (8, 000 km), CARRY OUT the PCM - Transmission Accelerated Main Control Break In routine 3 times using the diagnostic scan tool. For all other vehicles, INSTALL a new solenoid. REFER to: Shift Solenoids (SS) .
	F Clutch regulator valve sticking	If the vehicle has less than 5, 000 miles (8, 000 km), CARRY OUT the PCM - Transmission Accelerated Main Control Break In routine 3 times using the diagnostic scan tool. For all other vehicles, DISASSEMBLE, CLEAN and INSPECT the valves. If bore or valve is damaged, INSTALL a new main control valve body. REFER to: Main Control Valve Body .
	F CL CONTR hydraulic circuit blocked/leaking	DISASSEMBLE and INSPECT the main control valve body and separator plate passages for debris/blockage. CLEAN as necessary. REFER to: Main Control Valve Body .
	F clutch friction plates	DISASSEMBLE and INSPECT the transmission passages for debris/blockage. CLEAN as necessary. REFER to: Transmission
	F clutch piston return springs	DISASSEMBLE and INSPECT the transmission passages for debris/blockage. CLEAN as necessary. REFER to: Transmission