Symptom Chart
WARNING: This page is about a different variant/trim than selected.
For E clutch operation, REFER to: E Clutch .
| Condition | Possible Sources | Action |
|---|---|---|
| E clutch does not apply | SSE is mechanically stuck OFF | INSTALL a new solenoid. REFER to: Shift Solenoids (SS) . |
| E Clutch regulator valve stuck OFF | DISASSEMBLE, CLEAN and INSPECT the regulator valve. If bore or valve is damaged, INSTALL a new main control valve body. REFER to: Main Control Valve Body . | |
| E CL CONTR, hydraulic circuit blocked/leaking | DISASSEMBLE and INSPECT the main control valve body and separator plate passages for debris/blockage. CLEAN as necessary. REFER to: Main Control Valve Body . | |
| E clutch hub | INSPECT components wear and damage. CLEAN and/or INSTALL new components as necessary. REFER to: Transmission | |
| E clutch friction plates | INSPECT components wear and damage. CLEAN and/or INSTALL new components as necessary. REFER to: Transmission | |
| E clutch piston seals | INSPECT components wear and damage. CLEAN and/or INSTALL new components as necessary. REFER to: Transmission | |
| E clutch always applied | SSE mechanically stuck | INSTALL a new solenoid. REFER to: Shift Solenoids (SS) . |
| E Clutch regulator valve or CL E latch valve stuck ON | DISASSEMBLE, CLEAN and INSPECT the regulator valve. If bore or valve is damaged, INSTALL a new main control valve body. REFER to: Main Control Valve Body . | |
| E CL CONTR, hydraulic circuit cross leaks | DISASSEMBLE and INSPECT the main control valve body and separator plate passages for debris/blockage. CLEAN as necessary. REFER to: Main Control Valve Body . | |
| E clutch hub, clutch and planetary carrier, No. 4 ring gear | INSPECT components wear and damage. CLEAN and/or INSTALL new components as necessary. REFER to: Transmission | |
| E clutch friction plates | INSPECT components wear and damage. CLEAN and/or INSTALL new components as necessary. REFER to: Transmission | |
| E clutch piston seals | INSPECT components wear and damage. CLEAN and/or INSTALL new components as necessary. REFER to: Transmission | |
| E clutch delayed/soft/slipping apply | Incorrect transmission strategy programmed into PCM/TCM. | PERFORM the Transmission Strategy Download, REFER to: Transmission Strategy Download . |
| Low line pressure | PERFORM line pressure test. REFER to: Special Testing Procedures . | |
| SSE mechanically sticking | If the vehicle has less than 5, 000 miles (8, 000 km), CARRY OUT the PCM - Transmission Accelerated Main Control Break In routine 3 times
using the diagnostic scan tool. For all other vehicles, INSTALL a new solenoid. REFER to: Shift Solenoids (SS) . |
|
| E Clutch regulator valve sticking | If the vehicle has less than 5, 000 miles (8, 000 km), CARRY OUT the PCM - Transmission Accelerated Main Control Break In routine 3 times
using the diagnostic scan tool. For all other vehicles, DISASSEMBLE, CLEAN and INSPECT the valve. If bore or valve is damaged, INSTALL a new main control valve body. REFER to: Main Control Valve Body . |
|
| E CL CONTR, E CL-FB2 hydraulic circuits blocked/leaking | DISASSEMBLE and INSPECT the main control valve body and separator plate passages for debris/blockage. CLEAN as necessary. REFER to: Main Control Valve Body . | |
| E clutch friction plates | DISASSEMBLE and INSPECT the transmission passages for debris/blockage. CLEAN as necessary. REFER to: Transmission | |
| E clutch piston seals | DISASSEMBLE and INSPECT the transmission passages for debris/blockage. CLEAN as necessary. REFER to: Transmission | |
| E clutch harsh apply | Incorrect transmission strategy programmed into PCM/TCM. | PERFORM the Transmission Strategy Download, REFER to: Transmission |
| High line pressure | PERFORM line pressure test. REFER to: Special Testing Procedures . | |
| SSE mechanically sticking | If the vehicle has less than 5, 000 miles (8, 000 km), CARRY OUT the PCM - Transmission Accelerated Main Control Break In routine 3 times
using the diagnostic scan tool. For all other vehicles, INSTALL a new solenoid. REFER to: Shift Solenoids (SS) . |
|
| E Clutch regulator valve sticking | If the vehicle has less than 5, 000 miles (8, 000 km), CARRY OUT the PCM - Transmission Accelerated Main Control Break In routine 3 times
using the diagnostic scan tool. For all other vehicles, DISASSEMBLE, CLEAN and INSPECT the valve. If bore or valve is damaged, INSTALL a new main control valve body. REFER to: Main Control Valve Body . |
|
| E CL CONTR, E CL-FB2 hydraulic circuit blocked/leaking | DISASSEMBLE and INSPECT the main control valve body and separator plate passages for debris/blockage. CLEAN as necessary. REFER to: Main Control Valve Body . | |
| E clutch friction plates | DISASSEMBLE and INSPECT the transmission passages for debris/blockage. CLEAN as necessary. REFER to: Transmission | |
| E clutch piston return springs | DISASSEMBLE and INSPECT the transmission passages for debris/blockage. CLEAN as necessary. REFER to: Transmission |