Pinpoint Test M : DTC P0605, P0606, P0607, P06B8
WARNING: This page is about a different variant/trim than selected.
- Normal Operation and Fault Conditions
When the GSM initializes at key on it does internal memory and configuration tests, it sets a DTC when this test fails.
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition GSM P0605:00 Internal Control Module Read Only Memory (ROM) Error: No Sub Type Information When the GSM initializes at key on it does internal memory and configuration tests, it sets a DTC when this test fails. GSM P0606:00 Control Module Processor: No Sub Type Information When the GSM initializes at key on it does internal memory and configuration tests, it sets a DTC when this test fails. GSM P0607:00 Control Module Performance: No Sub Type Information When the GSM initializes at key on it does internal memory and configuration tests, it sets a DTC when this test fails. GSM P06B8:00 Internal Control Module Non-Volatile Random Access Memory (NVRAM) Error: No Sub Type Information When the GSM initializes at key on it does internal memory and configuration tests, it sets a DTC when this test fails. GSM P164E:00 Internal Control Module Transmission Range Select Performance: No Sub Type Information When the GSM initializes at key on it does internal memory and configuration tests, it sets a DTC when this test fails. Possible Sources
- Incorrect or corrupted GSM calibration.
- M1 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS)
- Ignition OFF.
- Ignition ON.
- Using a diagnostic scan tool, Program the GSM.
- Wait 10 seconds.
- Using a diagnostic scan tool, carry out the GSM self-test.
Are DTCs P0605, P0606, P0607, P06B8, P164E present?
Yes INSTALL a new GSM. REFER to: Gear Shift Module (GSM) . No The fault is may have been a faulty PCM calibration.