Crankshaft Pulley: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE: Component(s) must be lubricated with clean engine oil.

Lubricate the crankshaft front seal inner lip with clean engine oil.

Courtesy of FORD MOTOR COMPANY
NOTE: Component(s) must be lubricated with clean engine oil.

Lubricate the crankshaft pulley sealing surface with clean engine oil prior to installation.

Courtesy of FORD MOTOR COMPANY
Using the special tools, install the crankshaft pulley. Use Special Service Tool: 303-335 (T88T-6701-A) Installer, Front Cover Oil Seal., 303-1531 Installer, Front Crank Seal and Damper.

Courtesy of FORD MOTOR COMPANY
Using a universal pulley holder, install and tighten a new crankshaft pulley bolt.
Torque: Stage 1: 166 lb.ft (225 Nm) - Stage 2: Loosen: 360° - Stage 3: 26 lb.ft (35 Nm) - Stage 4: 270°

Courtesy of FORD MOTOR COMPANY
Install the accessory drive belt. Refer to: Accessory Drive Belt .
Install LH CAC intake pipe. Refer to: Charge Air Cooler (CAC) Intake Pipe .
Use the Powertrain Control Module (PCM) Misfire Monitor Profile Correction routine in the diagnostic scan tool.