Removal And Installation: Flexplate: Installation

WARNING: This page is about a different variant/trim than selected.

- NOTE: Special bolts are used for installation. Do not use standard bolts.
  
  Install the flexplate and the new bolts finger-tight.
- Install Special Service Tool: 303-103 (T74P-6375-A) Holding Tool, Flywheel.
- Tighten the bolts in sequence shown.
  Torque: Stage 1: 37 lb.ft (50 Nm) - - Stage 2: 59 lb.ft (80 Nm) - - Stage 3: 83 lb.ft (112 Nm)
Fig 1: Flexplate Tightening Sequence
Courtesy of FORD MOTOR COMPANY
Install the automatic transmission. Refer to: Transmission - 2.3L EcoBoost (201kW/273PS) .
Use the Powertrain Control Module (PCM) Misfire Monitor Profile Correction routine in the diagnostic scan tool.