Pinpoint Test I : P025A, P025B, P025C, P025D, P027B
WARNING: This page is about a different variant/trim than selected.
- Normal Operation and Fault Conditions
Refer to the DTC Fault Trigger Conditions below;
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition PCM P025A:00 Fuel Pump Module "A" Control Circuit/Open: No Sub Type Information This DTC sets when the PCM detects the FPC circuit is open or shorted to voltage or ground. PCM P025B:00 Fuel Pump Module "A" Control Circuit Range/Performance: No Sub Type Information This DTC sets when the fuel pump control module is still reporting that it is receiving an invalid duty cycle or frequency from the PCM after a calibrated amount of time. PCM P025C:00 Fuel Pump Module "A" Control Circuit Low: No Sub Type Information This DTC sets when the PCM detects the FPC circuit is shorted to ground. PCM P025D:00 Fuel Pump Module "A" Control Circuit High: No Sub Type Information This DTC sets when the PCM detects the FPC circuit is open or shorted to voltage. PCM P027B:00 Fuel Pump Module "B" Control Circuit Range/Performance: No Sub Type Information This DTC sets when the fuel pump control module 2 is still reporting that it is receiving an invalid duty cycle or frequency from the PCM after a calibrated amount of time. Possible Sources
- Fuel pump
- Fuel pump control module
- PCM
- Radio frequency interference or electromagnetic interference
- Wiring, terminals or connectors
- I1 DIAGNOSE THE CONCERN USING THE PC/ED (POWERTRAIN CONTROL/EMISSIONS DIAGNOSIS) INFORMATION
- Diagnose the concern using the PC/ED service information. (ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID) )
Did the diagnosis in PC/ED instruct to install a new BCM?
Yes Refer to BCM GUIDED ROUTINE . No Concern was resolved PC/ED.