Pinpoint Test H : U0404, U0405, U0416, U0428, U1014, U0102F
WARNING: This page is about a different variant/trim than selected.
- Normal Operation and Fault Conditions
Refer to ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS (EXCEPT DIESEL & HYBRID)
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition PCM U0404:00 Invalid Data Received from Gear Shift Control Module A: No Sub Type Information The PCM sets this DTC when the PCM receives invalid network data from the GSM. PCM U0405:00 Invalid Data Received From Cruise Control Module: No Sub Type Information The PCM sets this DTC when the PCM receives invalid network data from the CCM. PCM U0416:00 Invalid Data Received From Vehicle Dynamics Control Module: No Sub Type Information The PCM sets this DTC when the PCM receives invalid network data from the VDM. PCM U0428:00 Invalid Data Received From Steering Angle Sensor Module: No Sub Type Information The PCM sets this DTC when the PCM receives invalid network data from the SASM. PCM U102F:00 Invalid Internal Control Module Monitoring Data Received From All Wheel Drive Control Module: No Sub Type Information The PCM sets this DTC when the PCM receives invalid network data from the AWD control module. PCM U1014:00 Invalid Internal Control Module Monitoring Data Received from Restraints Control Module: No Sub Type Information The PCM sets this DTC when the PCM receives invalid network data from the RCM. Possible Sources
- Suspect Module
- H1 CHECK FOR DIAGNOSTIC TROUBLE CODES (DTCS) FROM THE MODULE SENDING INVALID DATA
- Using a diagnostic scan tool, carry out the self-test for the module in question sending the invalid data.
Are any Diagnostic Trouble Codes (DTCs) present from the module sending the invalid data?
Yes DIAGNOSE the module sending the invalid data. REFER to the appropriate information in the service information. No DIAGNOSE the observable symptom.