Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2020 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
With the ignition ON, the IPC sends messages to the SASM through the GWM and over the HS-CAN 3. If the SASM does not receive these messages within a certain time frame (usually less than 1 second), the SASM sets DTCs. For information on the messages sent to the SASM by the IPC, refer to the Network Message Chart in Description and Operation of the Anti-Lock Brake System (ABS) and Stability Control article.
PPT BB SASM DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | Sets in continuous memory and on-demand when the SASM detects any of the IPC messages are missing. This can be due to a IPC failure, a circuit failure on the HS-CAN or an excessive load on the network. |